You make it with a strip of paper. A good starting size is about 30cm, or 1 foot long, and about 1cm wide, or about half an inch.
Once you have made a couple, you can choose the length and width that you think makes the best star.
1. Start with a strip of paper. Tie a "knot" in the end of your paper.
|
2. Pull gently to tighten, then flatten.
| |
3. Fold the end of the strip down and tuck it into the knot.
You can cut a bit of it off if it's too long.
|
4. Now wrap the other end of the strip around and around this pentagon you have formed, creasing gently as you go.
| |
5. Keep wrapping until you get to the end of the strip.
Tuck the last bit of the strip into the pouch. You should be left with a cute little pentagon.
|
6. Now to make this little pentagon into a star, very gently and slowly use your fingernail to press on the centre of each of its edges. The star should puff out.
|
And you should have a lovely little lucky star!
It may take some practise to get the star to puff out perfectly, but stick with it... you’ll get it!
If you are having a lot of trouble, try different papers, or try wrapping the strip of paper around without creasing it too much. This helps a bit!
|
0 Comment "Origami Lucky Star Instructions"
Post a Comment